Applications



Applying Conditions
Appliation type
Navy

Red
Application wipe up
Thickness of film 0.02~10μm 0.02~6μm
Coating weight 0.02~40g/m2 0.02~30g/m2
Viscosity 9~10 seconds/HIS NK-2
Touch with fingers dryness 30minutes 15~20 minutes (20℃)
Room temperature dryness 24 hours, 3days for full indurations 24hours, 5~7 days for full induration
Compulsion dryness 70~80 ℃ x 30 minutes Full induration needs 1day at room temperature after compulsory dryness. 140~180 ℃ x 30 minutes Full induration needs 1~2days at room temperature after compulsory dryness.

Coating performance
Material :SUS304 Film thickness: 4 μm Conditions of cure: Room temperature for more than 3 days is tested after leaving.
Test itme Test condition Result
Navy Blue
The pencil hardness Coating hardness is checked using Mitsubishi Pencil YUNI. 8H 9H
Adhesion test Foundation eye tape way 2mm section 100 making Scotch tape test detached 100/100
Excoriation resistance Scouring pad test #0000 500 g load /100 reciprocation No abnormalities
Anti-shock test JIS K 5600-5-3 I accord with falling ball test. 300 g x 500 mm (25.4 mm of diameter) No abnormalities
Acid-proof test It's soaked in a 5% sulphuric acid solution for 24 hours at 20 ℃ No abnormalities
Alkali-proof test It's soaked in a calcium hydroxide saturated solution for 24 hours at 20 ℃ No abnormalities
Resistance to solvent Rubing test
(500g load/10 reciprocation)
Ethanol No abnormalities
Ether No abnormalities
Toluene No abnormalities
2-butanone ethyl methyl ketone No abnormalities
Resistance to hot water Tap water and 100 hour soaking (40 ℃) No abnormalities
Staining resistance The color difference which are pollution, the pollution side and non-pollution side in a carbon black ⊿ E = less than 0.5
Staining resistance Sunshine weather meter (2000 hours) Gloss retention more than 90%
The cycle of the heat and cold 60℃×3hr、-20℃×3hr(10 cycle) No abnormalities
Salt water resistance Sodium chloride solution 96 hour soaking ( Iron plate, sheet copper and Mg board) No abnormalities
PRTR way relevant Not applicable
RoHS order substance Not applicable
No abnormalitie: No change in the conditions
The above numerical value is a reference value, not standard value.


Attention on application of GIOS COAT
Avoid use at the bad environment bottom of air permeability.
Remove oil, water and dirt in the material surface sufficiently by agent removing fat.
Do application promptly. When it's left long, clogging and a coating blur are caused.
Manage so that the film thickness will be in the designated area. A crack is caused.
When drying, organic gas occurs, so please ventilate and exhaust sufficiently.
Preserve a coat pill at the cold and dark place.
This coat has the aptitude which reacts to water in the air, so please seal after use hermetically.
The use balance of a coat and the processing of a waste fluid be based on MSDS (product safe data seat), please.
Don't use at a place with flammable purpose fire.
Be careful sufficiently so that skin and a mucous membrane don't touch because there is stimulative in eyes in particular.
When touching, please wash for many water.
Refer to MSDS of a product about the in-depth contents.